LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1997 >> Forward Control 6.5 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - System/Component Tests - 5.7L.) >> Ignition System >> Timing Control Systems (C-4 & C-5) >> Internal Spark Controller Module)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Internal Spark Controller Module)

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 1996 GMC Yukon, 1996 GMC Vandura Special, 1996 GMC Vandura, 1996 GMC Suburban, and 1996 GMC Savana Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. An open or short circuit on knock sensor wire to ECM/PCM/VCM will set a related trouble code. A false detonation signal will not cause ECM/PCM/VCM to set a code.
  2. If a scan tester is available, connect it to Data Link Connector (DLC). Tap on engine next to knock sensor and note "knock" parameter. Knock should be indicated on scan tester.
  3. If a scan tester is not available, connect tachometer to engine. Start engine and hold RPM above idle. Using a metal object, tap on engine close to knock sensor. A noticeable decrease in engine RPM should occur. If no RPM decrease occurred, check knock sensor to ECM/PCM/VCM circuit.
  4. On vehicles equipped with automatic transmission, it may be necessary to place transmission in Drive for timing change to occur. See KNOCK SENSOR  under ENGINE SENSORS & SWITCHES.
scientia non olet · About LEMON Manuals