LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 1998 >> Forward Control 6.5 F >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (P Series) >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    Fig 1: Installing Flow Control Spring & Control Valve Assembly To Pump Housing Assembly
    G01467179Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring seal (3) to the connector and fitting assembly (4).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the connector and fitting assembly (4) to the pump housing (1).

    Tighten 

    Tighten the connector and fitting assembly (4) to 75 N.m (55 lb ft).

Fig 2: Installing Connector & O-Ring Seal To Pump Housing Assembly
G01467180Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals