LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2001 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 6.5L (L65) (Introduction) >> Repair Instructions >> Powertrain Control Module (PCM) Programming >> PCM Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PCM Programming

  1. Verify the following for the setup:
    • The battery is charged.
    • The ignition is ON.
    • The battery/cigarette lighter connection is secure.
    • The data link connector (DLC) is attached.
  2. Perform the programming. Refer to the up to date Techline terminal/equipment for user instructions.
  3. Perform the Passlock Learn Procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.
  4. After the vehicle has been programed, operate the vehicle until the coolant temperature is more than 77°C (170°F). This will allow the top dead center (TDC) offset to be programed. Refer to Programming the TDC Offset below.
  5. Check the Data list for a TDC offset.
  6. If the PCM fails to reprogram, do the following:
    • Check all the powertrain control module (PCM) connections.
    • Check the Techline terminal/equipment for the latest software version.
    • Try again to reprogram the PCM. If the PCM fails again, replace the PCM. Refer to Powertrain Control Module (PCM) Replacement .
scientia non olet · About LEMON Manuals