LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1414 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0568 (5.3L): Cruise Control Set Switch Circuit >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if condition is present.
DTC P0568 (5.3L)

Step Action Yes No
Schematic Reference : Cruise Control Schematics 
Connector End View Reference: Powertrain Control Module (PCM) Connector End Views in Engine Controls - 4.8L, 5.3L, and 6.0L
1 Did you perform the Cruise Control Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Cruise Control 
2 
  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. Turn the cruise On/Off control switch ON.
  4. With the scan tool, observe the Cruise Set/Coast Switch parameter in the PCM data list.
Does the Cruise Set/Coast Switch parameter display On?		 Go to Step 3  Go to Diagnostic Aids
3
  1. Turn the ignition OFF.
  2. Disconnect the cruise control switch.
  3. Turn the ignition ON, with the engine OFF.
  4. With the scan tool, observe the Cruise Set/Coast Switch parameter in the PCM data list.
Does the Cruise Set/Coast Switch parameter display On?		 Go to Step 4  Go to Step 5 
4 Test the cruise control set/coast switch signal circuit for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 6 
5 Inspect for poor connections at the harness connector of the cruise control switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 8 
6 Inspect for poor connections at the harness connector of the TAC module. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 7 
7 Replace the TAC module. Refer to Throttle Actuator Control (TAC) Module Replacement in Engine Controls - 4.8L, 5.3L, and 6.0L.
Did you complete the replacement?		 Go to Step 9  -
8 Replace the cruise control switch. Refer to Multifunction, Turn Signal Switch Replacement in Steering Wheel and Column.
Did you complete the replacement?		 Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals