Security Data

Auto Learn Timer:  The scan tool displays the seconds used by the BCM to learn valid code from the Passlock™ sensor. The learn procedure consists of 3 consecutive periods.

Battery Voltage:  The scan tool displays the battery system voltage.

Content Theft Lamp:  The scan tool displays the state of the SECURITY lamp. The scan tool displays ON when activated by an unauthorized entry.

Content Theft State  : The scan tool displays the state of the content theft feature. The scan tool displays ALARM when activated by an unauthorized entry.

Door Key Switch:  The scan tool displays the state of the door key switch. The scan tool displays ACTIVE when the switch is activated in either door key cylinder.

Ignition 1:  The scan tool displays ACTIVE when the ignition switch is in the RUN or CRANK position.

Ignition 3:  The scan tool displays ACTIVE when the ignition switch is in the RUN position.

Passlock™ Code:  The scan tool displays the validity of the Passlock™ code received by the BCM. The scan tool displays OPEN, SHORTED, TAMPER and a valid code as a numeric value (1-10).

Passlock™ Data Voltage:  The scan tool displays the voltage code from the Passlock™ sensor to the BCM. The BCM determines if the voltage received is a valid or invalid code voltage.

Passlock™ State:  The scan tool displays the state of the Passlock™ system.

Security Lamp State:  The scan tool displays the state of the SECURITY lamp. The scan tool displays ON, OFF or FLASHING.

Tamper Timer:  The scan tool displays the time remaining when in the tamper mode. The timer starts when the ignition switch is turned to the RUN position and the BCM receives a Passlock™ data voltage different from the last learned voltage. The timer has a delay of 10 minutes and will stay active even if the ignition switch is cycled from the RUN to the OFF position.

VCM/PCM Fall Enable:  The scan tool displays the state of the PCM fail enable mode. The scan tool displays YES when the Passlock™ system transitions from the Monitor Passlock™ Data state to the PCM Fail Enable state.

VCM/PCM Fuel Continue:  The scan tool displays the state of the PCM fuel continue mode. The scan tool displays YES when the Passlock™ system verifies a valid password to the BCM.

VCM/PCM Learn Timer:  The scan tool displays the state of the PCM learn timer. The scan tool displays INACTIVE when the BCM is not in a learn mode.

VTD Fuel Disable:  The scan tool displays the state of the VTD fuel disable mode. The scan tool displays INACTIVE when the Passlock™ system verifies a valid password.

VTD Fuel Disable Until Ignition Off:  The scan tool displays the state of the VTD fuel disable until Ignition off mode. The scan tool displays NO when the Passlock™ system verifies a valid password.

VTD Password Learn Mode:  The scan tool displays the state of the VTD password learn mode. The scan tool displays INACTIVE when the Passlock™ system is not in a learn mode.