LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1414 (Cruise Control System) >> Diagnostic Information and Procedures >> Diagnostic System Check - Cruise Control >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Lack of communication may be due to a malfunction in the class 2 serial data circuit. The specified procedure will determine the particular condition.
  2. 5:  The presence of DTCs which begin with "U" indicates that some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Diagnostic System Check - Cruise Control

Step Action Yes No
1 Install a scan tool.
Does the scan tool power up?		 Go to Step 2  Go to Scan Tool Does Not Power Up in Data Link Communications
2 
  1. Turn the ignition ON, with the engine OFF.
  2. Attempt to establish communication with the following modules:
    • Powertrain Control Module (PCM)
    • Electronic Brake Control Module (EBCM)
Does the scan tool communicate with the modules listed above?		 Go to Step 3  Go to Scan Tool Does Not Communicate with Class 2 Device (W/O Immobilizer)Scan Tool Does Not Communicate with Class 2 Device (W/ Immobilizer) in Data Link Communications
3
IMPORTANT: The engine may start during the following step. Turn the engine OFF as soon as you have observed the Crank power mode.
  1. With a scan tool, access the Class 2 Power Mode in the Diagnostic Circuit Check.
  2. Rotate the ignition switch through all positions while observing the System Power Mode parameter.
Does the System Power Mode parameter reading match the ignition switch position for all switch positions?		 Go to Step 4  Go to Power Mode Mismatch in Body Control System
4 Select the DTCs function on the scan tool for the following modules:
  • Powertrain Control Module (PCM)
  • Electronic Brake Control Module (EBCM)

Does the scan tool display any DTCs?		 Go to Step 5  Go to Symptoms - Cruise Control 
5  Does the scan tool display any DTCs which begin with a "U"? Go to Scan Tool Does Not Communicate with Class 2 Device (W/O Immobilizer)Scan Tool Does Not Communicate with Class 2 Device (W/ Immobilizer) in Data Link Communications Go to Step 6 
6 Does the scan tool display DTC P0562, P0563, P0621, or P0622? Go to Diagnostic Trouble Code (DTC) List in Engine Electrical Go to Diagnostic Trouble Code (DTC) List 
scientia non olet · About LEMON Manuals