LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (P Series) >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    Fig 1: Installing Flow Control Spring & Control Valve Assembly (P Series)
    G01669859Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring seal (3) to the connector and fitting assembly (4).
    NOTE: Refer to FASTENER NOTICE .
  4. Install the connector and fitting assembly (4) to the pump housing (1).

    Tighten 

    Tighten the connector and fitting assembly (4) to 75 N.m (55 lb ft).

    Fig 2: Installing O-Ring Seal & Connector/Fitting Assembly (P Series)
    G01669860Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals