LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> Engine Control Module Or Powertrain Control Module >> Service Programming System Remote Procedure (Corvette) >> PCM Programming Set Up With Special Tool
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

PCM Programming Set Up With Special Tool

  1. Ensure that the following conditions have been met:
    • The battery is fully charged.
    • The scan tool cable connection at the Data Link Connector (DLC) is secure.
  2. Turn OFF the ignition.
  3. Remove the passenger side floor access panel. See.
  4. Remove the splice pack/star connector shorting bars from both splice pack/star connectors. It may be necessary to remove splice pack/star connectors from the mounting positions.
  5. Install the star connector cable No. 1 from the Serial Data Link Tester to the 12-pin splice pack/star connector. This is the connector with 8 or 10 wires.
  6. Install the star connector cable No. 2 from the Serial Data Link Tester to the 12-pin splice pack/star connector. This is the connector with 4 wires.
  7. Select the star connector cable No. 1 on the Serial Data Link Tester toggle switch.
  8. Select position "B" on the Serial Data Link Tester.
Fig 1: Locating & Identifying Splice Pack/Star Connectors In Passenger Floor Access Panel
G00230116Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals