LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2004 >> Jimmy 2D Utility, Automatic, Standard >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Transfer Case - NVG 236-NP8 >> Repair Instructions >> Transfer Case Motor/Encoder Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Motor/Encoder Assembly
    GM662850Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.
  1. Install the motor/encoder to the transfer case.
  2. Install the motor/encoder gasket to the transfer case.
    NOTE: Refer to Fastener Notice in Cautions and Notices.

    Install motor/encoder mounting bolts to the transfer case.

    Tighten:  Tighten the motor/encoder mounting bolts to 20 N.m (15 lb ft).

    3. Fig 2: View Of Motor/Encoder Electrical Connector
    GM662851Courtesy of GENERAL MOTORS CORP.
  3. Install the motor/encoder electrical connector.
  4. Install the transfer case shield. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals