Installation Procedure

Fig 1: Locating Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating Screws Retaining Control Button Assembly To Steering Wheel

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the control button assembly (2) to the steering wheel with the two screws (1).
Tighten: Tighten the screws to 1.5 N.m (13 lb in).

Fig 3: Locating Screws Retaining Horn Contact Plate To Steering Wheel

Courtesy of GENERAL MOTORS CORP.

Install the horn contact plate to the steering wheel with the screws (1).
Tighten: Tighten the screws to 5.5 N.m (50 lb in).
Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.