Brake Switch (Cruise Control): Service and Repair

Cruise Release Switch Replacement

Removal Procedure






Important: When replacing the switch, always replace the retainer.

1. Disconnect the electrical connector from the cruise release switch.
2. Complete the following in order to remove the cruise release switch from the brake pedal bracket:

1. Rotate the switch counter clockwise.
2. Pull the switch from the retainer.
3. Push the locking tabs inward to release the retainer.

3. Remove the retainer.

Installation Procedure





1. Slide only the cruise release switch retainer into the brake pedal bracket, until the locking tabs are fully engaged.
2. Connect the electrical connector to the cruise release switch.
3. Adjust the cruise release switch. Refer to Cruise Release Switch Adjustment.