Electronic Brake Control Module Programming and Setup

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

EBCM Reprogramming-Refer to Control Module References Control Module References.

EBCM Reprogramming

If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS) Service Programming System (SPS).

Setup for Component Replacement

The brake fluid pressure sensor is not serviceable. After replacing a brake fluid presure sensor, it may be necessary to perform a brake pressure sensor calibration with the Tech 2 special function, if the DTC resets as a current code.