LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2012 >> Acadia SL, FWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls/Fuel - 3.6L - DTC P0340 To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P2534 (Fuel Pump Control Module) >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Verify that DTC P0562 is not set.
  2. Ignition OFF, disconnect the harness connector of the FPCM.
  3. Ignition ON, test for greater than 11 volts between the IGN voltage circuit terminal 15 and ground.
    • If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit test normal and the ECM - IGN fuse 58 is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the Run/Crank relay.
  4. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals