Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative.

Paint the front object alarm sensor.
Ensure the paint does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals.

Fig 1: Identifying Rear Object Sensor Housing

Courtesy of GENERAL MOTORS COMPANY

Insert the sensor into the housing.
Connect the electrical connector to the front object alarm sensor.
Install the front bumper fascia. Refer to Front Bumper Fascia Replacement Front Bumper Fascia Replacement (V) .