Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Verify the scan tool parameter: Liftgate Front Control Switch = Inactive
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S45B Liftgate Control Switch - Interior - Pressed
Verify the scan tool parameter: Liftgate Front Control Switch = Active
- If not the specified state
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
- If not the specified state
- Operate the component: S45B Liftgate Control Switch - Interior - Select each position: Off/3/4/Max
Verify the scan tool parameter: Liftgate Mode Switch = Off & 3/4 & Maximum
- If the parameter value does not change
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the parameter value changes
- If the parameter value does not change
- All OK.