Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install Multifunction Energy Storage Capacitor Control Module (2)
- Install and tighten Multifunction Energy Storage Capacitor Control Module Nut (1) (Qty: 2) to 9 N.m (80 lb in)
- Install Auxiliary Generator Battery Jumper Cable (2) (Qty: 3)
- Install and tighten Auxiliary Generator Battery Jumper Cable Nut (1) (Qty: 3) to 12 N.m (106 lb in)
- Connect the electrical connectors (3).
- Install Multifunction Energy Storage Capacitor Control Module Bracket (2)
- Install and tighten Multifunction Energy Storage Capacitor Control Module Bracket Bolt (1) (Qty: 2) to 9 N.m (80 lb in)
- Install and tighten Multifunction Energy Storage Capacitor Control Module Bracket Bolt (3) (Qty: 2) to 9 N.m (80 lb in)
- Install Active Safety Control Module Bracket (2) {If equipped }
- Install and tighten Active Safety Control Module Bracket Bolt (1) to 2.5 N.m (22 lb in) {If equipped }
- Install Rear Compartment Side Trim. Refer to Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe)
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Perform Stop/Start Capacitor Control State Health Reset. Refer to Stop/Start Capacitor Control State of Health Reset
CAUTION:
Refer to Fastener Caution .