LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2018 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> DTC B2462: Global Positioning System (GPS) Signal (without IO5/IO6) >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF/vehicle OFF, disconnect the GPS coax cable connector at the K73 Telematics Communication Interface Control Module.
  2. Connect the EL-49903-1  OnStar Test Antenna, Navn-Cell Comn to the K73 Telematics Communication Interface Control Module. Place the test antenna on the roof of the vehicle, ignition ON/vehicle in Service Mode.
  3. Verify DTC B2462 is not set or that the OnStar advisor can locate the vehicle.
    • If DTC B2462 is set or the advisor can not locate the vehicle 

      Replace the K73 Telematics Communication Interface Control Module.

    • If DTC B2462 is not set or that the OnStar advisor can locate the vehicle. 
  4. Ignition OFF/vehicle OFF, disconnect the EL-49903-1  OnStar Test Antenna, Navn-Cell Comn from the K73 Telematics Communication Interface Control Module
  5. Disconnect the GPS coax cable at the T2RR Antenna - Roof Rear.
  6. Test the coax cable between the K73 Telematics Communication Interface Control Module and the T2RR Antenna - Roof Rear. Refer to component testing.
    • If the coax cable does not pass the test 

      Replace the coax cable.

    • If the coax cable passes the test 
  7. Test or replace the T2RR Antenna - Roof Rear.