Accessory AC and DC Power Control Module Bracket Replacement

WARNING: This page is about a different car, the 2021 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection Front Floor Console Rear Trim Panel Replacement (with Rear Vent) , or Front Floor Console Rear Trim Panel Replacement (with Auxiliary Heater and AC Control) Reposition the carpet, if necessary.
1	Accessory AC and DC Power Control Module Bolt [2x] CAUTION: Fastener Caution Tighten 2.5 N.m (22 lb in)
2	Accessory AC and DC Power Control Module Bracket Procedure Disconnect the electrical connector. Transfer components as necessary. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection

Callout

Component Name

Preliminary Procedures

Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
Front Floor Console Rear Trim Panel Replacement (with Rear Vent) , or Front Floor Console Rear Trim Panel Replacement (with Auxiliary Heater and AC Control)
Reposition the carpet, if necessary.

Accessory AC and DC Power Control Module Bolt [2x]

CAUTION:

Fastener Caution

Tighten
2.5 N.m (22 lb in)

Accessory AC and DC Power Control Module Bracket

Procedure

Disconnect the electrical connector.
Transfer components as necessary.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection