Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure :

1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
2. Ignition - On / Vehicle - In Service Mode
3. Access SPS and follow the on-screen instructions for the control module : Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module

   Verify the control module programming is successful.

   • If the programming is not successful 
   1. Ignition/Vehicle - Off - For greater than 1 min
   2. Ignition - On / Vehicle - In Service Mode
   3. Access SPS and follow the on-screen instructions for the control module : Q8 Control Solenoid Valve Assembly or K71 Transmission Control Module
      • If the programming is not successful - Replace the component : Q8 Control Solenoid Valve Assembly
      • Go to next step : If the programming is successful
   4. Select : Setup
   5. All OK.
   • Go to next step : If the programming is successful 
4. Select : Setup
5. All OK.