Circuit/System Testing
WARNING: This page is about a different car, the 2021 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X1 harness connector at the P17 Info Display Module.
- Test for less than 10 Ω between the ground circuit terminal 10 and ground.
- If 10 Ω or greater
- Ignition OFF.
- Test for less than 2 Ω in the ground circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, repair the open/high resistance in the ground connection.
- Go to next step: If less than 10 Ω
- Verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If the test lamp does not illuminate
- Ignition OFF, remove the test lamp.
- Test for less than 2 Ω in the B+ circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- Go to next step: If the test lamp illuminates
- Verify the LVDS interface cable is properly connected at the P17 Info Display Module and the A11 Radio and there is no damage to the cable or connections.
- Ignition ON/Vehicle in Service Mode, infotainment system ON.
- Verify the P17 Info Display Module displays an image.
- If the P17 Info Display Module does not display an image.
Replace LVDS interface cable from the P17 Info Display Module to the A11 Radio.
- Ignition ON/Vehicle in Service Mode, infotainment system ON.
- Verify the P17 Info Display Module displays an image.
- If the P17 Info Display Module does not display an image.
Replace the P17 Info Display Module.
- If the P17 Info Display Module does not display an image.
- Ignition ON/Vehicle in Service Mode, infotainment system ON.
- Verify the P17 Info Display Module displays an image.
- If the P17 Info Display Module does not display an image.
Replace the A11 Radio.
- Go to next step: If the P17 Info Display Module displays an image
Go to next step: All OK.
- If the P17 Info Display Module does not display an image.
- Go to next step: If the P17 Info Display Module displays an image.
- If the P17 Info Display Module does not display an image.
- All OK.