Replace and Program Control Module

To program a replacement K107 Drive Motor Control Module perform the following procedure:

1. Replace the K107 Drive Motor Control Module.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
NOTE:

The K107 Drive Motor Control Module, K107B Drive Motor Control Module 2 and K107C Drive Motor Control Module 3 will be programmed together.

3. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
4. 1. Place the keyless entry transmitter in the programming pocket prior to proceeding with the next step. All additional transmitters must be at least 3 m (9.8 ft) away from the vehicle. Refer to the Remote Keyless Entry (RKE) System Operation document in the owner manual for the exact pocket location. This document is located in the Keys, Doors, and Windows > Keys and Locks category.
   NOTE:

   To prevent errors or immobilizer learn failure, the vehicle must be in Park.

   NOTE:

   If DTC B1987 sets immediately after programming a replacement K107 Drive Motor Control Module, the Immobilizer Learn procedure was not properly completed. The Immobilizer Learn procedure needs to be performed again.

   NOTE:

   The Immobilizer Learn process may take between 10-12 min and progress will appear to have stopped during this process. This is a normal security timer response and a restart should not be performed.
5. On the SPS Supported Controllers screen, select Z1 Immobilizer Learn. On the next screen, select Drive Motor Control Module IMMO Learn and follow the on-screen instructions.
6. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Setup and follow the on-screen instructions.
7. Clear DTCs.