Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
2. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
3. Verify the control module programming is successful.
   • If the programming is not successful 
   1. Vehicle Off. Wait for greater than 1 min.
   2. Vehicle On/Service Mode
   3. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
      • If the programming is not successful - Replace the appropriate component: K107C Drive Motor Control Module 3 or K107 Drive Motor Control Module or K107B Drive Motor Control Module 2
      • Go to next step: If the programming is successful
   4. All OK.
   • Go to next step: If the programming is successful 
4. All OK.