Replace and Program Control Module
NOTE:
- The swing gate must be completely closed and latched, if the swing gate is open or ajar during programming, the power swing gate system may become inoperative without any DTCs indicated
- Verify all modules are connected and communicating before attempting to program the K194 Rear Gate Module.
To program a replacement control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K194 Rear Gate Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K194 Rear Gate Module - Setup and follow the on-screen instructions.
- Clear DTCs