LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2017 >> G80 3.8, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (3 Of 3) - 3.8L >> DTC P0630: VIN Not Programmed or Incompatible-ECM/PCM >> DTC Inspection >> Monitor GDS Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IG "ON".
  3. Select "Diagnostic Trouble Codes (DTC)  " button, Press "DTC Status" to check DTC's information from the DTCs menu.
  4. Does the ECM (PCM) have a stored VIN?

    YES 

    • Fault is intermittent caused by poor contact in Sensor's and/or ECM (PCM)'s connector or was repaired and ECM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals