Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.

Connect the GDS on the Data Link Connector (DLC).
If there is DTC on the GDS, replace the FPCM.
Check the output voltage of fuel pressure sensor (FPS).
Specification: 5V

Courtesy of
Check the output voltage of fuel pressure sensor (FPS) at idle.
Specification: 1.4 ~ 3.2 V

Courtesy of
Test the lower fuel pressure line.

(Refer to Fuel Delivery System - "FUEL PRESSURE TEST ")

Specification: Refer to "Specification "