LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Supplemental Restraint System Control Module & Sensors) >> Occupant Classification System (OCS) >> Repair Procedures >> Installation >> OCS Mat
April 5, 2026: LEMON Manuals is launched! Read the announcement.

OCS Mat

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the OCS Mat equipped seat cushion assembly on the front seat assembly.

    (Refer to Body - "FRONT SEAT ")

  2. Connect the OCS mat connector.
  3. Install the front passenger seat assembly.

    (Refer to FRONT SEAT ASSEMBLY Body )

  4. Reconnect the battery negative cable.
  5. After installing the OCS, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
    NOTE: Be sure to perform OCS zeroing with GDS after replacing OCS equipped seat cushion.
scientia non olet · About LEMON Manuals