LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2018 >> G80 3.8, AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Assembly >> Transfer Case Assembly >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

  1. To install, reverse the removal procedure.
    CAUTION: In case of replacing the controller (ECU) and transfer case due to changing characteristics of the frictional materials inside the transfer case, it is necessary to check and enter the calibration data.
    • The calibration procedure is not required in case of replacing the transfer case and ITA (ECU) at the same time.
    • In case of replacing the Transfer Case Assembly only, perform the Clutch Learning Reset in the ITA (ECU).

      (Refer to 4 Wheel Driving (AWD) System - "GENERAL INFORMATION-REPAIR PROCEDURE ")

    • In case of replacing the ITA (ECU) only, perform the Clutch Learning back-up and writing in the new transfer Case ITA (ECU) using GDS equipment.

      (Refer to 4 Wheel Driving (AWD) System - "GENERAL INFORMATION - REPAIR PROCEDURE ")

scientia non olet · About LEMON Manuals