| Main Action |
|
- Open in ground circuit
- Short to battery in signal circuit
- Open in signal circuit
- Poor connection or damaged harness
- Faulty TPS1
|
| Case 1 |
Prerequisite condition |
- Ignition switch is turned "ON".
|
| Threshold Value |
- TPS1 output voltage is higher than 4.9V
- Sensor signal circuit is open or shorted to power supply circuit.
|
| Case 2 |
Prerequisite condition |
- Ignition switch is turned "ON".
- Engine is running at idle.
- Targeted throttle angle is lower than 58%.
- TPS2 failure is detected.
|
| Threshold Value |
- TPS1 output voltage at idle is higher than 3.0V
- Sensor signal circuit is open or shorted to power supply circuit.
|
| Diagnostic Time |
|
| Mil On Condition |
|