Monitor DTC Status

Connect GDS and select "DTC Analysis" mode.
Turn "ON" the ignition switch.
Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
Read the "DTC Status" parameter.
Record all DTCs, DTC state and freeze frame data before clearing them. Is the DTC State "Present?".
NOTE:
- History (Not Present) fault: DTC occurred but has been cleared.
- Present fault: DTC is occurring at present time.
YES
- Go to next procedure.
NO
- This can be an intermittent fault caused by poor contact of the sensor and/or ECM connector. Or, ECM memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".