LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2019 >> G70 3.3T Advanced, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis - 3.3L (6 Of 6) >> DTC U0109-00: Lost Communication With Fuel Pump Control Module >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
  2. Ignition switch is turned "ON".
  3. Using a GDS, Clear DTC.
  4. Ignition switch is turned "OFF".
  5. Disconnect ECM connector connected to P-CAN bus.
  6. Ignition switch is turned "ON".
  7. Connect GDS and select "Diagnostic Trouble Codes (DTC)" mode.
  8. Are any DTCs present?

    YES 

    • Go to step  1 of the component inspection and disconnect another ECM connector connected to CAN bus in step 5.
    • Repeat above step until test completed on all ECM in CAN bus.
    • If DTC is present after the above test, substitute with a known-good FPCM and check for proper operation. If problem is corrected, replace FPCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals