LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2019 >> G70 3.3T Advanced, AWD >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

  1. Turn the engine OFF.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  3. Install the SRSCM with the SRSCM mounting bolts (A) (3).

    Tightening torque: 

    7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 lb-ft)

    G13540716Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Use new mounting bolts when replacing the SRSCM after a collision.
    • When installing the SMSCM bolt, install the ground wire (A) with a bolt as indicated in the picture.
      G13540717Courtesy of HYUNDAI MOTOR AMERICA
  4. Connect the SRSCM harness connector.
  5. Install the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ASSEMBLY ")

  6. Reconnect the battery negative cable.
  7. After installing the SRSCM, confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    CAUTION: If the SRSCM is replaced always, perform variant coding. Also, perform the lateral G sensor 0 point setup.
    (Refer to Brake System - "ADJUSTMENT ")
scientia non olet · About LEMON Manuals