| Main Action |
|
- Poor connection
- Open or short to battery in signal harness
- Open in ground harness
- TPS
- ECM
|
| Case 1 |
Prerequisite condition |
- Ignition switch is turned "ON"
|
| Threshold Value |
- The voltage of TPS 1 is greater than 4.9V.
- Sensor signal circuit is open or shorted to battery power supply.
|
| Case 2 |
Prerequisite condition |
- Ignition switch is turned "ON"
- Engine is operating state (at idle)
- Accelerator pedal value is lower than 0.01%
- TPS set point is less than 61.078°.
- TPS 2 failure or TPS 1 versus TPS 2 ratio failure is detected.
|
| Threshold Value |
- TPS 1 output voltage at idle is greater than 2.998V.
- Sensor signal circuit is open or shorted to battery power supply.
|
| Diagnosis Time |
|
| MIL On Condition |
|