Repair Procedures: Removal: Notes

WARNING: This page is about a different variant/trim than selected.

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
Remove the water center pipe.
(Refer to Engine Mechanical System - "WATER TEMPERATURE CONTROL ASSEMBLY ")

Disconnect the connector (A), and then remove the CVVT oil pressure sensor (B).

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

When removing and installing the oil temperature sensor, use a deep socket as shown in the image below.

3/8" drive deep socket (24 mm) with the wall thin and the length less than 75 mm.

Courtesy of HYUNDAI MOTOR AMERICA