LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2021 >> G70 2.0T, RWD, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Keyless Entry And Burglar Alarm >> Repair Procedures >> Inspection >> Front Door Lock Module Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Front Door Lock Module Inspection

  1. Remove the front door trim.

    (Refer to Body - "FRONT DOOR TRIM ")

  2. Remove the front door module.

    (Refer to Body - "FRONT DOOR MODULE ")

  3. Disconnect the connectors from the actuator
    G14177773Courtesy of HYUNDAI MOTOR AMERICA
  4. Check actuator operation by connecting power and ground as shown in illustration below. To prevent damage to the actuator, apply battery voltage only momentarily

    [Central lock] 

    G14177774Courtesy of HYUNDAI MOTOR AMERICA
    G14177775Courtesy of HYUNDAI MOTOR AMERICA

    [Dead lock + Key switch] 

    G14177776Courtesy of HYUNDAI MOTOR AMERICA

    [Dead lock] 

    G14177777Courtesy of HYUNDAI MOTOR AMERICA
    G14177778Courtesy of HYUNDAI MOTOR AMERICA
  5. Perform the cinching reset procedure in case of faulty operation of the cinching of the power door latch (automatic full latching). (1) Cinching reset procedure is completed by "Remove power door fuse → Install power door fuse → IGN ON".
    Power door fuses Fuse mounting location
    Driver"s seat Front Smart Junction Box
    Passenger
scientia non olet · About LEMON Manuals