| DTC Strategy |
|
- Poor connector connection
- Air leak in Intake or Exhaust System
- Faulty injector
- Faulty fuel pressure
- Faulty HO2S
|
| Enable Condition |
- Vehicle speed more than 20 km/h (12.43 MPH)
- Atmospheric pressure more than 75 kPa
- Temperature above 720°C (1328°F) of front oxygen sensor tip for more than 70 seconds of front oxygen sensor heating time
- Temperature above 635°C (1175°F) of rear oxygen sensor tip for more than 80 seconds of rear oxygen sensor heating time
- Difference between the lambda setting value and the actual value is less than 0.25
- Temperature above 50°C (122°F) of ECT
- Rear oxygen sensor voltage more than 0.6V
- Engine torque is between 10 - 20 Nm and 100 - 200 Nm (depending on engine speed)
- Catalyst model temperature 470 - 930°C (878 - 1706°F)
- Engine speed is between 832 and 3168 RPM
- Engine load s between 9 - 11% and 35 - 42%
- Driving condition
- Difference between the actual engine speed and the filtered engine speed is less than 320 RPM
- Difference between the actual intake air volume and the filtered intake air volume is less than 130mg/stroke
- Difference between the actual lambda value and the filtered lambda value is less than 7%
- Intake air value is more than 2.0g
- Lambda control activated
|
| Threshold Value |
- When the ratio between actual oxygen sensor value and model value is greater than 1
|
| Diagnostic Time |
|
| MIL ON Condition |
|