| DTC Strategy |
Case 1 |
- TPS position learning condition check
|
- Poor connector connection
- Faulty TPS1 or TPS2 Sensor
- Faulty ETC Motor
|
| Case 2 |
- ETC limp home position check
|
| Case 3 |
|
| Enable Condition |
- No throttle position learning
|
| Threshold Value |
Case 1 |
- Inability to study due to dissatisfaction with the TPS learning condition
|
| Case 2 |
- Difference between the TPS sensor and the limp home set point voltage is more than 0.4V
|
| Case 3 |
- TPS1 signal voltage is less than 0.36V and TPS2 signal line is more than 4.46V
- TPS1 signal voltage is less than 0.16V and TPS2 signal line is more than 4.26V
|
| Diagnostic Time |
|
| MIL ON Condition |
|