Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF and disconnect the battery negative (-) cable.
Remove the Engine Room Cover.
(Refer to Engine Mechanical System - "ENGINE COVER ")
Disconnector the ECM connector (A).
Disconnector the TCM connector (B).

Courtesy of HYUNDAI MOTOR AMERICA
After removing the ECM bracket installation nuts (A), remove the ECM bracket assembly.
Tightening torque:

7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
After removing the installation nuts (A), remove the ECM from the bracket.
Tightening torque:

7.8 - 11.7 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.6 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA