LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System Diagnosis >> DTC P0880: TCM Power Input Signal >> Wiring Inspection >> Ground Circuit Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Ground Circuit Inspection

  1. IG "OFF" & Disconnect TCM connector.
  2. Measure voltage between pin No. 4 (or pin No. 5 & pin No. 6) ground terminal of TCM harness connector and chassis ground.

    Specification:  Below 1Ω

  3. Is the measured value within specifications?

    YES 

    • Fault might be intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO