LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2021 >> GV80 3.5T Advanced+ >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> Occupant Classification System (OCS) >> Repair Procedures >> Installation >> Occupant Classification System (OCS) Unit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Occupant Classification System (OCS) Unit

  1. Install the OCS ECU and sensor on the front seat assembly.
  2. Connect the OCS ECU connector.
  3. Install the front passenger's side seat assembly.

    (Refer to Body (Interior and Exterior) - "FRONT SEAT ASSEMBLY ")

  4. Reconnect the battery negative (-) terminal.
  5. After installing the OCS, confirm proper system operation.
    NOTE:
    • Turn the ignition switch ON the SRS indicator should be turned on for about 6 seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
    • Be sure to perform OCS reset with GDS after replacing OCS equipped seat cushion.
scientia non olet · About LEMON Manuals