LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2023 >> G80 2.5T Advanced, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Airbag Module And Clock Spring) >> Center Side Air Bag Module >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
    WARNING:
    • Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Place a front center side airbag on the side airbag frame and tighten the front center side airbag mounting nuts.

    Tightening torque: 

    5.9 - 7.8 N.m (0.6 - 0.8 kgf.m, 2.9 - 5.8 lb-ft)

  3. Install a new seat back cover.

    (Refer to Body (Interior and Exterior) - "FRONT SEAT BACK COVER ")

    NOTE:
    • Make sure that the airbag assembly cover is installed properly. Improper installation may prevent a proper deployment.
  4. Install a front seat assembly.

    (Refer to Body (Interior and Exterior) - "FRONT SEAT ASSEMBLY ")

  5. Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfered by other parts.
  6. Reconnect the negative (-) battery terminal.
  7. After installing the front center side airbag, confirm proper system operation.
    NOTE:
    • Turn the ignition switch ON; the SRS indicator light should turn on for about 3-6 seconds and then go off.
scientia non olet · About LEMON Manuals