Repair Procedures: Removal
WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
- Switch "OFF" the ignition and disconnect the battery negative (-) terminal.
- Disconnect the accelerator position sensor connector (A).
- Disconnect the upper mounting cap (B), and remove the mounting nut (C).
- Disconnect the lower mounting cap (D), and remove the mounting bolt (E).
Tightening torque:
8.8-13.7 N.m (0.9-1.4 kgf.m, 6.5-10.1 lb-ft)