ETC Module Learning Procedure
WARNING: This page is about a different car, the 2024 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
When replacing new ETC module or reinstalling it, ETC module learning procedure must be performed.
- Hold the start button or ignition key at the IGON position for 1 minute.
- After starting the engine, keep the idle state for 15 minutes.
- Turn the ignition key or the start button off and hold for 1 minute.
- Re-start the engine and check the idle roughness.NOTE:
- If the ETC module learning procedure is not performed after replacing or reinstalling it, MIL illumination with DTCs may occur.