September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Ignition Switch Test
- Using test light connected to ground, backprobe White wire and
Black/Red wire terminal of ignition switch connector. Connector is
located behind lower instrument panel. Test light should glow.
- If test light does not glow, check fusible link AM2. Fusible
link box is located on positive battery cable. Check for open in
wiring circuit to ignition switch. See appropriate chassis wiring
diagram in WIRING DIAGRAMS
.
- Turn ignition switch to START position. Using a test light,
backprobe Black/White wire terminal at ignition switch connector
(start circuit) and Blue/Red wire terminal (ignition power circuit).
Test light should glow. If test light does not glow at either
terminal, replace ignition switch.