LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Geo >> 1994 >> Prizm Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments >> Valve Clearance
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Valve Clearance

CAUTION: Valve clearance should be checked with engine cold.
VALVE CLEARANCE SPECIFICATIONS

Application In. (mm)
Exhaust (1) .010-.014 (.25-.35)
Intake (1) .006-.010 (.15-.25)
(1) Adjustments made with engine cold.
  1. Disconnect negative battery cable. Remove valve cover and gaskets. Rotate crankshaft until No. 1 cylinder is at TDC of compression stroke. Ensure timing mark on crankshaft pulley aligns with zero mark on timing belt cover.
  2. Valves on No. 1 cylinder should have clearance and be closed. If both valves on No. 1 cylinder are not closed, rotate crankshaft one revolution (360 degrees).
  3. Using feeler gauge, measure and record clearance between camshaft lobe and adjuster shim on intake valves of cylinders No. 1 and 2, and exhaust valves of cylinders No. 1 and 3. Adjust valve clearance if not within specification. See VALVE CLEARANCE SPECIFICATIONS table.
  4. Rotate crankshaft one revolution (360 degrees). Check clearance on intake valves of cylinders No. 3 and 4, and exhaust valves of cylinders No. 2 and 4. Adjust valve clearance if not within specification. See VALVE CLEARANCE SPECIFICATIONS table.
  5. To adjust valve clearance, rotate crankshaft until camshaft lobe is pointing upward, away from adjuster shim. Install Spring Compressor (J-39871-1) between camshaft and adjuster shim to push lifter downward. See Fig 1.
  6. Insert Lifter Detainer (J-39871-2) between camshaft and lifter. Ensure bottom edge of lifter detainer is positioned on lifter, not on adjuster shim. See Fig 1. This will hold lifter away from camshaft.
  7. Remove spring compressor. Using small screwdriver and magnet, remove adjuster shim. Replacement adjuster shim thickness can be determined by using adjuster shim charts. See Fig 2 and Fig 3 . Adjuster shim thickness can also be determined by using following formula: N = T + A
    • N = Thickness of adjuster shim required.
    • T = Thickness of adjuster shim removed.
    • A = Measured clearance minus valve clearance specification.
  8. To install NEW adjuster shim, depress valve spring using spring compressor. Install adjuster shim. Remove lifter detainer and spring compressor.
  9. Ensure valve clearance is within specification. To install remaining components, reverse removal procedure.
Fig 1: Adjusting Valve Clearance
G50J07256Courtesy of GENERAL MOTORS CORP.
Fig 2: Determining Exhaust Valve Adjuster Shim
G93E78083Courtesy of GENERAL MOTORS CORP.
Fig 3: Determining Intake Valve Adjuster Shim
G93F78084Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals