Mechanical Inspection: Compression
- Check engine mechanical condition using a compression gauge, vacuum gauge or engine analyzer. See engine analyzer manual for specific instructions. See COMPRESSION SPECIFICATIONS table.
- Start engine and allow to reach normal operating temperature. Turn ignition to LOCK position. Remove all spark plugs. Disconnect distributor electrical connector and remove FI fuse from fuse box.
- Install compression gauge. Disengage clutch on manual transaxle equipped vehicles to reduce drag on engine. Fully depress accelerator pedal to Wide-Open Throttle (WOT) position. Using a fully charged battery, crank engine to specified RPM. See COMPRESSION SPECIFICATIONS table. On each cylinder, record highest of 4 compression gauge readings and compare with table.
COMPRESSION SPECIFICATIONS
| Application |
Specification |
| Compression Ratio |
9.5:1 |
| Normal Compression Pressure |
199 psi (14.0 kg/cm2
) |
| Minimum Compression Pressure |
156 psi (11.0 kg/cm2
) |
| Maximum Variation Between Cylinders |
14 psi (1.0 kg/cm2
) |