Service Precautions

Observe following precautions when working with air bag systems:

• When working around steering column and/or instrument panel components, and before any repairs are performed, disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
• Before straightening any damage to body, or before performing electrical arc-welding, disable air bag system, and disconnect air bag control module.
• If air bag module or seat belt tensioner is dropped from a height greater than 18 inches it must be replaced.
• Always wear safety glasses and gloves when handling a deployed air bag module or ETR module. Air bag module may contain sodium hydroxide deposits which are irritating to the skin.
• DO NOT repair any SRS component or wiring harness. SRS servicing requires replacement of faulty component. DO NOT use components previously installed on another vehicle. Only use SRS components supplied by manufacturer.
• Always handle air bag module with trim cover away from body. Always place air bag module on workbench with trim cover up, away from loose objects.
• DO NOT expose any SRS component to temperatures in excess of 212°F (100°C).
• DO NOT leave SRS components unattended. If work is interrupted, SRS component should be stored in a secure, locked area.
• DO NOT expose any SRS component to cleaning agents or other solvents, grease, gasoline, etc.
• If SRS is not fully functional for any reason, vehicle should not be driven until system is repaired and again becomes operational. DO NOT remove bulbs, modules, sensors or other components or in any way disable system from operating normally. If SRS is not functional, park vehicle until it is repaired and functions properly. See SYSTEM OPERATION CHECK .