Canada models

Partially remove the left inner fender (see FRONT INNER FENDER REPLACEMENT ).
Disconnect the 2P connector (A) from the washer fluid level switch (B).

Fig 1: Identifying Washer Fluid Level Switch 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the washer fluid level switch from the washer reservoir.
NOTE: Fluid may flow out of the opening.
Check for continuity between the No. 1 and No. 2 terminals in each float position.
- There should be continuity when the float is down.
- There should be no continuity when the float is up.
If the continuity is not as specified, replace the switch.
If the continuity is as specified, go to step 5 in GAUGE CONTROL MODULE INPUT TEST , do the test for terminal C18.