DTC B1060, DTC B1061: Relay Control Module Lost Communication with Gauge Control Module (VSP/NE or A/T message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Is DTC B1060 and/or B1061indicated?
- YES - Go to step 5.
- NO - Intermittent failure, the communication line is OK at this time. Check for loose or poor connection between the relay control module and the gauge control module.
- Check for DTCs with the HDS.
B1060: Are DTCs B1011, and B1205 also indicated? B1061: Is DTC B1008 also indicated?
- YES - Do the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ).
- NO - Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).