General Specifications

Cylinder Head

Torque 40 Nm (4.0 kgf-m, 29 lbf-ft)





Tighten in two steps 90° per step
New bolt torque an extra 90°





Measure the diameter of each cylinder head bolt at point A and point B.





If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.

Intake Manifold





Torque the bolts/nuts in a crisscross pattern in three steps, beginning with the inner bolt.

Camshaft Bearing Cap





Main Bearing Cap

Torque 30 Nm (3.0 kgf-m, 22 lbf-ft).





Tighten additional 56°.

Rod Bearing Cap

Torque 20 N-m (2.0 kgf-m, 15 lbf-ft).

Tighten an additional 90°.

Crankshaft Pulley

Torque 50 Nm (5.0 kgf-m, 37 lbf-ft)





Tighten additional 90°

Oil Pump





Exhaust Manifold





Torque the bolts/nuts in a crisscross pattern in two or three steps, beginning with the inner bolt.

Water Pump