LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2010 >> Element SC, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Navigation System) >> System Description >> Rearview Camera Connector for Inputs and Outputs >> Rearview Camera 12P Connector
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rearview Camera 12P Connector

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rearview Camera 12P Connector
G06971105Courtesy of AMERICAN HONDA MOTOR CO., INC.

Rearview Camera 12P Connector 

TERMINALS DESCRIPTION CHART

Cavity Wire Color Terminal Name Description Voltage (about) Symptom
1 BLU CAMERA VCC Power source for rearview camera 8V If open: When put into reverse, the navigation screen goes black (backlight still operation) If short to ground: When put into reverse, the navigation screen goes black (backlight still operative).
2 RED CAMERA VGND Ground for rearview camera 0V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
3 GRN GND (RC) Ground for rearview camera In reverse: battery voltage If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
4 WHT CAMERA V Video signal for rearview camera 0.3 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
5 GRY(1) CAMERA SH Shield for terminals No. 1, No. 2, No. 3, No. 4, and No. 6 -- --
6 YEL CAMERA ADPT Control signal for rearview camera 0V If open: No change to display.
If short to ground: No effect on system.
7 BRN CAMERA BIT 0 Mode select signal for rearview camera Normal view: 8V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
8 ORN CAMERA BIT 1 Mode select signal for rearview camera Top down view: 8 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
9 Not used Not used -- -- --
10 Not used Not used -- -- --
11 Not used Not used -- -- --
12 Not used Not used -- -- --
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the circuit diagram.